For some of our legacy equipment, you will need to manually adjust the clock due to Daylight Savings Time.
Fig 1.1 rocker switch
Facing the Entry Terminal, remove the panel on the left side. See above image of the SysParc Controller Board. On the cover of this board in the lower left corner is a rocker switch with”Prog./Step” (fig 1.1). You will use this rocker switch to step through the function to correct daylight-saving times. By depressing and releasing in either direction, the “Prog.” Or “Step” switch will make one advancement. So, remember to depress the switch once and remove your finger so you do not double step the advancement. Missing selection will require you to cycle through to selection again.
- Depress the “Prog.” once
The screen changes from Welcome to the Day and time, you will notice the underscore is under the
number month - Depress the “Prog.” once
The screen shows the underscore under the numerical day date - Depress the “Prog.” once
The screen shows the underscore under the numerical year - Depress the “Prog.” once
The screen shows the underscore under the military time display (ex: 07:00 7AM, 11:00 11AM, 14:00 2PM,
22:00 10PM) - With the underscore under the hour segment, this is where you will make the hour correction.
(You will now use the “Step” switch to advance the hour value, you cannot go backwards) - Depress the “Step” once
The “Step” part of the switch and this will advance the hour by one. You will need to depress the “Step” switch
until the correct time is displayed. Once correct time is displayed we will proceed to finish the procedure. - Depress the “Prog.” onc
The screen shows the underscore under the minutes - Depress the “Prog.” once
The screen shows the underscore under the seconds - Depress the “Prog.” once
The screen will display “Set Display Message” - Depress the “Prog.” once
The screen will display “Set Line 1” - Depress the “Prog.” once
The screen will display “Set Line 2” - Depress the “Prog.” once
The screen will display “Set Line 3” - Depress the “Prog.” once
The screen will display “Set Site ID” - Depress the “Prog.” once
Blank screen will be displayed - Depress the “Prog.” once
The screen will display “End of Message
The screen should display “Welcome to your garage“. You are finished setting the time, pull a ticket to verify time has changed on the printed ticket.